1.3.3. [0x39] Section

The [0x39] section of the CONFIG file defines conferencing parameters applicable to all conferencing lines. Parameters are modified by editing (or adding) the respective lines in the [0x39] section of the CONFIG file.

Note: Only modifications to the ToneClamping parameter are supported in this CONFIG file section. The ToneClamping parameter applies only to Dialogic Integrated Series boards.

Tone clamping is enabled by default. To disable tone clamping, the ToneClaming parameter (parameter number=0x3925) must be added to the CONFIG file and set to a value of 0.

Note: For Dialogic Integrated Series boards, disabling tone clamping also requires modifications to the [0x3b.x] sections of the CONFIG file. For details, see Section 1.3.5, [0x3b.x] Section.

Following is an excerpt from the [0x39] section of a CONFIG file that illustrate that part of the file before and after editing.

[0x39] before editing:

[0x39]
SetParm=0x3926,16 ! Total # of parties (Conf_MaxTotalParties)
                  ! per conferencing board. 

[0x39] after editing:

[0x39]
SetParm=0x3925,0  ! Disable Tone Clamping
SetParm=0x3926,16 ! Total # of parties (Conf_MaxTotalParties)
                  ! per conferencing board. 

To enable tone clamping, delete the ToneClamping parameter from the [0x39] section of the CONFIG file.

For information about each [0x39] parameter, see Section 4.3, [0x39] Parameters.

Click here to contact Telecom Support Resources