1.3.5. [0x3b.x] Section

The [0x3b.x] section of the CONFIG file defines conferencing parameters specific to each conferencing line. There is an [0x3b.x] section for each line. For example, [0x3b.1] applies to conferencing line 1, [0x3b.2] applies to conferencing line 2, and so on.

Parameters are modified by editing (or adding) the respective lines in each [0x3b.x] section of the CONFIG file.

Note: Only modifications to the NotificationTone parameter are supported in this CONFIG file section. The NotificationTone parameter applies to QuadSpan Voice, DualSpan Voice, and Dialogic Integrated Series boards.

On DM3 boards, the conference notification tone is enabled by default. To disable the conference notification tone, the NotificationTone parameter (parameter number=0x3b06) must be added each line and set to a value of 0.

Note: For Dialogic Integrated Series boards, disabling tone clamping also requires modifications to the [0x39] section of the CONFIG file. For details, see Section 1.3.3, [0x39] Section.

Following is an excerpt from the [0x3b.x] sections of a DI/0408-LS-A CONFIG file (three conferencing lines) that illustrate that part of the file before and after editing.

[0x3b.x] before editing:

[0x3b.1]
SetParm=0x3b05,0  ! Tariff Tone OFF 
[0x3b.2]
SetParm=0x3b05,0  ! Tariff Tone OFF 
[0x3b.3]
SetParm=0x3b05,0  ! Tariff Tone OFF 

[0x3b.x] after editing:

[0x3b.1]
SetParm=0x3b05,0  ! Tariff Tone OFF
SetParm=0x3b06,0  !Notification Tone OFF 
[0x3b.2]
SetParm=0x3b05,0  ! Tariff Tone OFF
SetParm=0x3b06,0  !Notification Tone OFF 
[0x3b.3]
SetParm=0x3b05,0  ! Tariff Tone OFF
SetParm=0x3b06,0  !Notification Tone OFF 

To enable the conference notification tone, delete the NotificationTone parameter from each conferencing line, that is, each [0x3b.x] section of the CONFIG file.

For information about each [0x3b.x] parameter, see Section 4.5, [0x3b.x] Parameters.

Click here to contact Telecom Support Resources