4.16.2. Wink (Wink Flag)

Description: The Wink parameter enables Wink detection for outbound and Wink generation for inbound calls. This parameter is enabled only when using T-1 E&M wink protocols. For all other protocols, this parameter is disabled.

If Wink detection (generation) is enabled, up to three winks are supported in a sequence. Examples of CONFIG file settings for ANI, Wink, DNIS, and R4Compatibility parameters for 1, 2, and 3 wink sequences are as follows:

• 1 Wink Example: Seize (Wink) DNIS (Answer) ANI

  Variant ANI 2 ! No=0, Pre=1, Post=2
Variant Wink 1 ! 1 wink sequence
Variant DNIS y ! Enable DNIS collection
SetParm=0x1310,1 ! R4 Compatibility Flag
! 0=default, 1=enable, 2=disable

  In the 1 Wink example, ANI information is collected after the call is answered, there is one wink in the sequence, DNIS information is collected, and the R4 Compatibility Flag is turned on.

• 2 Wink Example: Seize (Wink) ANI (DNIS) (Wink) Answer

  Variant ANI 1 ! No=0, Pre=1, Post=2
Variant Wink 2 ! 1 wink sequence
Variant DNIS y ! Enable DNIS collection
SetParm=0x1310,1 ! R4 Compatibility Flag
! 0=default, 1=enable, 2=disable

  In the 2 Wink example, ANI information is collected before the call is answered, there are two winks in the sequence, DNIS information is collected, and the R4 Compatibility Flag is turned on.

• 3 Wink Example: Seize (Wink) DNIS (Wink) ANI (Wink) Answer

  Variant ANI 1 ! No=0, Pre=1, Post=2
Variant Wink 3 ! 1 wink sequence
Variant DNIS y ! Enable DNIS collection
SetParm=0x1310,2 ! R4 Compatibility Flag
! 0=default, 1=enable, 2=disable

  In the 3 Wink example, ANI information is collected before the call is answered, there are three winks in the sequence, DNIS information is collected, and the R4 Compatibility Flag is turned off.

Values:

• 0 or n = Disable wink
• 1 or y = Enable 2 winks in the sequence
• 2 = Enable 1 wink in the sequence
• 3 = Enable 3 winks in the sequence

Click here to contact Telecom Support Resources