4.19. [TSC] defineBSet Parameters

The parameters defined by the defineBSet command in the [TSC] section of the CONFIG file are associated with the B channel sets. The syntax of the defineBSet command is:

defineBSet = SetId, LineId, StartChan, NumChans, BaseProtocol, Inbound, OutBound, DChanDesc, Admin, Width, BChanId, SlotId, Direction, Count, [BChanId, SlotId, Direction, Count,] 0

Note: The [TSC] defineBSet parameters do not have parameter numbers explicitly defined within the CONFIG file.

• SetId (Set Identifier)
• LineId (Line Identifier)
• StartChan (Start Channel)
• NumChans (Number of B Channels)
• BaseProtocol (Base Protocol)
• Inbound (Inbound Variant)
• Outbound (Outbound Variant)
• DChanDesc (D Channel Identifier)
• Admin (Admin)
• Width (Width)
• BChanId (B Channel Identifier)
• SlotId (Slot Identifier)
• Direction (Direction)
• Count (Count)

Click here to contact Telecom Support Resources