4.19.6. Inbound (Inbound Variant)

Description: The Inbound parameter selects one of the protocol type variant parameter sets defined in the [CHP] section of the CONFIG file to use for inbound calls. The protocol variant defines the type of protocol running on the set of B channels. This is set to 0 to clear the channels or disable inbound calls.

For example, on T-1 ISDN lines, Inbound is set to a value of 1 as follows:

defineBSet=10,1,1,23, 0,1,1,1,20,1, 1,1,3,23,0
defineBSet=20,2,1,23, 0,1,1,1,20,1, 1,1,3,23,0
defineBSet=30,3,1,23, 0,1,1,1,20,1, 1,1,3,23,0
defineBSet=40,4,1,23, 0,1,1,1,20,1, 1,1,3,23,0 

This parameter is also set to 0 for clear channel. Clear channel is the ability to access telephony channels in the system and configure them to a user defined call control protocol, or to simply leave the lines 'clear'. The resources should have access to the telephony bus for media routing purposes, as well as signal detection, signal generation, and tone generation capabilities, if desired.

Values:

• 0 = Clear channel (disable inbound calls)
• n = Variant identifier as defined in the [CHP] section of the CONFIG file

Click here to contact Telecom Support Resources