4.20. [0x1b] Parameters

The [0x1b] section only appears in CONFIG files that are associated with IPLink boards. The following parameters only apply to IPLink boards:

• PrmAGCActive (AGC Enable)
• PrmAGCnf_attfast (Fast Attack Filter Coefficient)
• PrmAGCnf_attslow (Slow Attack Filter Coefficient)
• PrmAGCgain_inc_speech (Maximum Gain Attach Rate)
• PrmAGCmax_gain (Maximum Gain Limit)
• PrmAGCMEM_max_size (Maximum Memory Size)
• PrmAGCMEM_sil_reset (Memory Size Reset)
• PrmAGClow_threshold (Noise Floor Estimate)
• PrmAGCk (Target Output Level)
• PrmCEDCadence (CED Cadence)
• PrmCNGCadenceMin (CNG Minimum Cadence)
• PrmCNGCadenceMax (CNG Maximum Cadence)
• PrmCNGCadenceSilence (CNG Silence)
• PrmDTMFGainCtrl (DTMF Gain Control)
• PrmDTMFVolCrtl (DTMF Volume Control)
• PrmDTMFDurationDflt (DTMF On Time)
• PrmDTMFOffTimeDflt (DTMF Off Time)
• PrmDTMFXferMode (DTMF Transmission Mode)
• PrmECActive (Echo Cancellation)
• PrmECOrder (Number of Taps)
• PrmECNLPActive (NLP Enable)
• PrmECMu (Convergence Rate)
• PrmECResSpFlagEnableDisable (Residual Speech Flag)
• PrmECSuppressGain (Suppress Gain)
• PrmGainCtrl (Gain Control)
• PrmVolCtrl (Volume Control)
• PrmOptLatPktsTx (PLR Optimal Latency)
• PrmMaxLatPktsTx (PLR Maximum Latency)
• PrmRedDepth (Redundancy)
• PrmFaxEnable (Fax Enable)
• PrmT38ECOverride (ECM Override)
• PrmT38DFOverride (Limit Image Encoding Method)
• PrmT38BROverride (Limit Modulation and Bit Rates)
• PrmT38TCFThrshld (Local Training Maximum Error Tolerance)
• PrmT38IndSecBlocks (Fax IND Redundancy Factor)
• PrmT38V21SecBlocks (Fax V21 Redundancy Factor)
• PrmT38HSECMSecBlocks (Fax HSECM Redundancy Factor)
• T38HSSecBlocks (Fax HS Redundancy Factor)
• PrmT38HSEOFSecBlocks (Fax HSEOF Redundancy Factor)
• PrmT38HSEOTSecBlocks (Fax HSEOT Redundancy Factor)
• PrmT38TxThrshld (Transmit Hold Back Threshold)
• PrmT38TCFMethod (Local or End-to-End Training)
• PrmT38TxPower (Transmit Power Level)
• PrmT38SpoofLevel (Spoofing Level)
• PrmHPFActive (HPF Enable)

Click here to contact Telecom Support Resources