4.5.1. NotificationTone (Conferencing Notification Tone)

Parameter Number: 0x3b06

Description: The NotificationTone parameter is the used to disable the conferencing notification tone on QuadSpan Voice, DualSpan Voice, and Dialogic Integrated Series boards. The conferencing notification tone is generated to alert conferees when a party enters or exits a conference. This tone is enabled by default on DM3 boards and the NotificationTone parameter is added to the CONFIG file to disable the tone.

Note: To disable the tone clamping on Dialogic Integrated Series boards, modifications to the ToneClamping parameter are also required. For details, see Section 4.3.1, ToneClamping (Tone Clamping).

To disable the conferencing notification tone, the NotificationTone parameter must be added to the [0x3b.x] sections of the CONFIG file and set to a value of 0. Each [0x3b.x] section applies to a specific conferencing line. That is, [0x3b.1] applies to conferencing line 1, [0x3b.2] applies to conferencing line 2, and so on.

For QuadSpan Voice and DualSpan Voice there are 30 conferencing lines, and therefore, 30 [0x3b.x] sections in the CONFIG file: [0x3b.1] through [0x3b.30].

For the DI/0408-LS-A Dialogic Integrated Series board, there are three conferencing lines, and therefore, three [0x3b.x] sections in the CONFIG file: [0x3b.1] through [0x3b.3].

For the DI/SI-16, DI/SI-24. and DI/SI-32 Dialogic Integrated Series boards, there are five conferencing lines, and therefore, five [0x3b.x] sections in the CONFIG file: [0x3b.1] through [0x3b.5].

To enable the conferencing notification tone, the NotificationTone parameter must be removed from the [0x3b.x] sections of the CONFIG file.

Values: 0

Click here to contact Telecom Support Resources