4.15.3. DisableBlock (Disable Block)

Parameter Number: 0x1312

Description: The DisableBlock parameter defines whether or not a blocking pattern (message) is sent on a channel when the channel is in the OutofService state. When DisableBlock is disabled, no pattern is sent (the switch will not present calls to the B channel).

When DisableBlock is enabled and a channel is in the InService state (InitialChanState=1), the protocol will send a non-blocking pattern on the channel (the switch will present calls to the B channel). When DisableBlock is enabled and a channel is in the OutofService state (InitialChanState=2), the protocol will send a blocking pattern on the channel (the switch will present calls to the B channel but these calls will be abandoned by the switch since the application will not respond to the call).

Values:

• 0 = Disable blocking
• 1 = Enable blocking

Click here to contact Telecom Support Resources