4. Parameter Reference

This section lists the parameters contained in the CONFIG files. Not all parameters are included in each CONFIG file, as this depends on the board supported by that particular file. For a list of supported boards and associated CONFIG files, see Chapter 3, Boards and Applicable CONFIG File Sections.

Note: CONFIG file parameters that should not be modified by the user are omitted from this document. Exceptions are made for parameters that, although they should not be modified by the user, are needed in understanding a particular set of parameters (for example, the [TSC] defineBSet Width parameter). For these exceptions, the parameter description states that the value should not be modified by the user.

Parameters are listed in the same order as they appear in the CONFIG files and they are grouped according to the CONFIG file sections. Within the CONFIG files, the parameters are grouped in the following sections:

• [encoder] Parameters
• [recorder] Parameters
• [0x39] Parameters
• [0x3b] Parameters
• [0x3b.x] Parameters
• [lineAdmin.x] Parameters
• [NFAS] Parameters
• [NFAS.x] Parameters
• [CAS] Parameters for T-1 E&M Signals
• [CAS] Parameters for T-1 Loop Start Signals
• [CAS] Parameters for T-1 Ground Start Signals
• [CAS] User-defined CAS and Tone Signal Parameters
• [CAS] User-defined Signals for Selectable Rings Parameters
• [CCS] Parameters
• [CHP] Parameters
• [CHP] T-1 Protocol Variant Definitions
• [CHP] ISDN Protocol Variant Definitions
• [TSC] Parameters
• [TSC] defineBSet Parameters
• [0x1b] Parameters
• [NetTSC] Parameters
• [0x1d] Parameters
• [0x1c] Parameters

Click here to contact Telecom Support Resources