4.2. GCIS_SET_BEARERCHNL Parameter Set

Table 22 shows the parameter IDs for the GCIS_SET_BEARERCHNL set ID.

Note: The GCIS_SET_BEARERCHNL parameter set is not supported when using DM3 boards. Use gc_MakeCall( ) to set and gc_GetSigInfo( ) to retrieve bearer channel information transfer capability or information transfer rate. Setting the bearer channel information transfer rate is not supported, but gc_GetSigInfo( ) can be used to retrieve bearer channel information transfer mode.

Table 22. GCIS_SET_BEARERCHNL Parameter IDs 

Parameter ID	Type	Description
GCIS_PARM_TRANSFERMODE	int	Bearer channel Information Transfer Mode. Valid values are: ISDN_ITM_CIRCUIT ISDN_ITM_PACKET Note: If this parameter is not present in the makecall block, then CCLIB will use the value set through RTCM.
GCIS_PARM_TRANSFERRATE	int	Bearer channel, Information Transfer Rate. Valid values are: BEAR_RATE_64KBPS BEAR_RATE_128KBPS BEAR_RATE_384KBPS BEAR_RATE_1536KBPS BEAR_RATE_1920KBPS Note: If this parameter is not present in the makecall block then CCLIB will use the value set through RTCM.

Click here to contact Telecom Support Resources