PCCS6 Configuration File with Circuits and Signaling on DTI Trunks
* - 1 PCCS6 in SCBus slave mode
* - 2 circuit groups on Dialogic DTI trunks (e.g. D/300SC-E1)
* - 2 SS7 links routed over the SCBus from timeslot 16 of Dialogic DTI trunks
* (ISDN firmware, e.g. CTR4, is required for this, with parameter 16 set to
* 2 in corresponding PRM file)
*
*
* Physical interface parameters :
* PCCS6_BOARD <port_id> <board_id> <num_pcm> <flags> <code_file>
*
PCCS6_BOARD 0 0 0 0x00C2 isup76.dc2
*
* Configure individual E1/T1 interfaces:
* LIU_CONFIG <board_id> <liu_id> <liu_type> <line_code> <frame_format> <crc_mode>
LIU_CONFIG 0 0 5 1 1 1
LIU_CONFIG 0 1 5 1 1 1
*
* MTP Parameters :
* MTP_CONFIG <local_spc> <ssf> <options>
*
MTP_CONFIG 2 0x8 0x0000
*
* Define linksets :
* MTP_LINKSET <linkset_id> <adjacent_spc> <num_links> <flags>
*
MTP_LINKSET 0 0x1 2 0x0000
*
* Define signalling links :
* MTP_LINK <link_id> <linkset_id> <link_ref> <slc> <board_id> <blink> <stream> <timeslot> <flags>
*
* [link src=dtiB1T31]
MTP_LINK 0 0 0 0 0 0 0x12 0x01 0x0006
* [link src=dtiB2T31]
MTP_LINK 1 0 1 1 0 1 0x12 0x02 0x0006
*
* Define a route for each remote signalling point :
* MTP_ROUTE <dpc> <linkset_id> <user_part_mask>
*
MTP_ROUTE 1 0 0x0020
*
* ISUP Parameters :
* ISUP_CONFIG <local_pc> <ssf> <user_id> <options> <num_grps> <num_ccts>
*
ISUP_CONFIG 2 0x8 0x4d 0x0474 4 64
*
* Define ISUP circuit (groups) :
* [trunk_name]
* ISUP_CFG_CCTGRP <gid> <dpc> <base_cic> <base_cid> <cic_mask> <options>
*
* [dtiB1]
ISUP_CFG_CCTGRP 0 1 0x01 0x01 0x7fff7fff 0x001e
* [dtiB2]
ISUP_CFG_CCTGRP 1 1 0x21 0x21 0x7fff7fff 0x001e
*
*
* End of file
*
