1.5. Supported Configurations

• 1.5.1. DM3 Boards With On-board Network Interface
• T1 ISDN Configuration
• E1 ISDN Configuration
• T1 CAS (Robbed Bit Signaling) Configuration
• 1.5.2. DM3 Resource Boards With DTI Network Interface in Transparent ISDN Mode (Fax Only Applications)
• T1 ISDN Configuration
• E1 ISDN Configuration
• 1.5.3. DM3 Resource Boards in SCbus Mode (Multimedia Applications)
• 1.5.4. Board Based on Dialogic's Springware Architecture
• 1.5.5. CP boards With On-board Network Interface
• 1.5.6. CP Resource Boards With DTI Network Interface in Transparent ISDN Mode (Fax Only Applications)
• T1 ISDN Configuration
• E1 ISDN Configuration
• 1.5.7. CP Resource Boards in SCbus Mode (Multimedia Applications)

NOTE:

Dialogic recommends that you install the board in your system before installing the software. The installation instructions that follow assume the board is already installed.

There are seven possible configurations:

• DM3 boards with on-board network interfaces
• DM3 resource boards with DTI network interfaces in transparent ISDN mode
• DM3 resource boards in SCbus mode
• Board based on Dialogic's Springware architecture
• CP boards with on-board network interfaces
• CP resource boards with DTI network interfaces in transparent ISDN mode
• CP resource boards in SCbus mode

An explanation of each configuration follows.

1.5.1. DM3 Boards With On-board Network Interface

T1 ISDN Configuration

Hardware: CPi/2400CT-T1

Possible Protocols: 4ESS, 5ESS, DMS, NTT

E1 ISDN Configuration

Hardware: CPi/3000CT-E1

Possible Protocol: CTR4 (also called Net5 or Euro ISDN)

T1 CAS (Robbed Bit Signaling) Configuration

Hardware: CPi/2400CT-T1

Possible Protocols: E&M, Loop Start, Ground Start

1.5.2. DM3 Resource Boards With DTI Network Interface in Transparent ISDN Mode (Fax Only Applications)

T1 ISDN Configuration

Hardware: CPi/2400CT with DTI/240SC

Possible Protocols: Any ISDN protocol supported by the DTI/240SC card

E1 ISDN Configuration

Hardware: CPi/3000CT with DTI/300SC

Possible Protocols: Any ISDN protocol supported by the DTI/300SC card

1.5.3. DM3 Resource Boards in SCbus Mode (Multimedia Applications)

1.5.4. Board Based on Dialogic's Springware Architecture

Hardware: BRI/2VFD

Possible Protocol: CTR3 (also known as Euro ISDN)

1.5.5. CP boards With On-board Network Interface

Hardware: Any CP board (listed in the CP Boards section) except CP6/SC and CP12/SC

1.5.6. CP Resource Boards With DTI Network Interface in Transparent ISDN Mode (Fax Only Applications)

T1 ISDN Configuration

Hardware: 2 CP12/SCs with DTI/240SC

Possible Protocols: Any ISDN protocol supported by the DTI/240SC card

E1 ISDN Configuration

Hardware: 2 CP12/SCs and a CP6/SC with DTI/300SC

Possible Protocols: Any ISDN protocol supported by the DTI/300SC card

1.5.7. CP Resource Boards in SCbus Mode (Multimedia Applications)

Click here to contact Dialogic Customer Engineering