2.2. Installing Dialogic Software

NOTE:

The software is installed from the Dialogic System Release (SR)
CD-ROM. This guide assumes that Dialogic's hardware is already installed in the system

1. Run SETUP.EXE from the Dialogic SR CD-ROM and follow the screen prompts.

Figure 1. Setup Options Window

2. From the Setup Options window, choose the CUSTOM option.

WARNING

If you choose the TYPICAL option, the GDK components
will not be installed.

Once you have selected the Custom option, the Custom Component Selection window appears.

Figure 2. Custom Component Selection Window

3. From the Custom Component Selection Window, select only the GDK component. Click Clear All and then select the GDK component by placing a check mark in the box adjacent to GDK.

The recommended Custom Component Selection window appears.

Figure 3. Custom Component Selection Window

1. Click Next after selecting only the GDK component.

A Question dialog box appears:

Figure 4. Question Dialog Box

5. Click No.

NOTE:

If you select YES, all the components needed to support all the possible configurations are automatically installed on your disk. This option utilizes a large amount of disk space, and is not recommended for most installations.

If you select No, you return to the Custom Component Selection window, which has all the necessary GDK components selected for you.

NOTE:

Previously selected components remain checked.

Figure 5. Custom Component Selection Window

6. From the Custom Component Selection window, click Clear All.

Figure 6. Custom Component Selection Window

Click here to contact Dialogic Customer Engineering