Active or Inactive Parameters

• DM3 or CP Resource Boards With DTI Network Interface in Transparent ISDN Mode (Fax Only Applications)
• DM3 Boards With On-board Network Interface
• All Other Supported Configurations

Not all the parameters accessible via the GDK Configuration Utility are used by all the different configurations. This section describes which specific parameters are used by each configuration.

NOTES:

1. If you are not an advanced user, do not attempt to use any settings except those on the Main configuration tab. The parameters that are related to the other configuration tabs are loaded using the predefined Configuration profiles.

2. Parameters that are not accessible via the GDK Configuration Utility in certain configurations may be accessible by other means e.g. via config or .prm files as described earlier in this manual.

DM3 or CP Resource Boards With DTI Network Interface in Transparent ISDN Mode (Fax Only Applications)

All parameters from all tabs are active.

DM3 Boards With On-board Network Interface

Table 26. GDK Configuration Utility - Active Parameters

TAB	STATUS
Dispatcher	All parameters are active.
ISDN In	No parameter is active except "Use ACCEPTED State" in the "ISDN Feature" group.
ISDN Out	All parameters are inactive except "Origination Phone Number" in the "Make Call Block" group.
Error Mapping	The "GammaLink Error Mapping" group is active. The other parameters are inactive.
Debug	The "Debug / Logs" group is active. The other parameters are inactive.

All Other Supported Configurations

The other supported configurations include:

• DM3 Resource Boards in SCbus Mode (Multimedia Applications)
• CP Resource Boards in SCbus Mode (Multimedia Applications)
• Board Based on Dialogic's Springware Architecture
• CP Boards with On-board Network Interface

Table 27. GDK Configuration Utility - Active Parameters

TAB	STATUS
Dispatcher	In this configuration, the "Activate Transparent PRI Layer" has to be unchecked. In this case, all other parameters on this tab are inactive
ISDN In	All parameters are inactive.
ISDN Out	All parameters are inactive.
Error Mapping	All parameters are inactive.
Debug	The "Debug / Logs" group is active, all other parameters on this tab are inactive.

Click here to contact Dialogic Customer Engineering