5.4.5. Disabling Intel Dialogic Performance Counters - Windows 2000/Windows XP

To disable the Intel Dialogic performance counters, perform the following procedure:

1. Exit the Windows Performance Monitor.
2. Close any application that writes to or reads from the Intel® Dialogic drivers.
3. Stop the Intel Dialogic System.

   For information about starting and stopping the Intel Dialogic System, see Section 5.1, Starting and Stopping the Intel® Dialogic System.

4. Invoke the Windows command line.
5. Make the current directory <Install Directory>\Dialogic\Bin.
6. Execute perfcctl.exe. The Dialogic Performance Counters dialog box appears.
7. Uncheck the Enabled box and then click OK. A Warning box appears that contains the following instructions:

   "To Disable the performance counters:

   1. Stop the Dialogic System Service (via DCM).

   2. Stop the drivers by typing NET STOP DLGCSRAM at the Command Prompt.

   3. Start the Dialogic System Service (via DCM)."

8. Perform steps 1 and 2 of the above instructions and then click OK. The following message is then displayed:

   "The Dialogic SRAM Protocol Driver Service was stopped successfully."

   For information about starting and stopping the Intel® Dialogic System, see Section 5.1, Starting and Stopping the Intel® Dialogic System.

9. Perform step 3 of the above instructions (Start the Dialogic System Service.)

   The performance counters are now disabled.

Click here to contact Telecom Support Resources