5.6.3. Installing the Intel® Dialogic System Software with Terminal Services Running on Windows 2000

The installation procedure in Section 2.5, Installing Intel Dialogic System Release 5.1.1 Software tells you to begin the install by inserting the CD-ROM and by locating and double-clicking the Setup.exe file if the installation doesn't begin automatically.

However, if you have Terminal Services running on Windows 2000, a terminal server must be in install mode before you can install a program. When you try to double-click a setup, you will receive a message that explains this (Figure 31):

Figure 31. Terminal Server Install Failure

Follow these steps to start the installation of the Intel® Dialogic System Software:

1. Go to the Control Panel by clicking the link (Add/Remove Programs) on the message box (Figure 31).

   Or you can click OK (this simply closes the message box but doesn't start the install) and go to Start > Settings > Control Panel. Then select Add/Remove Programs.

   The Add/Remove Programs screen appears (Figure 32).

Figure 32. Add/Remove Programs

2. Select Add New Programs on the left and then select CD or Floppy (Figure 32). The Install Program From Floppy Disk or CD-ROM screen appears (Figure 33).

Figure 33. Install Program Screen

3. Click Next. A screen will appear to prompt for the path to the setup.exe file (Figure 34).

Figure 34. Run Installation Program - Browse

4. Click Browse to select the path to Setup.exe.
5. Click Next. The install will now run.
6. Follow the instructions given in Section 2.5, Installing Intel Dialogic System Release 5.1.1 Software.
7. When the installation is complete, you will be prompted to click Next and Finish on the last two "install mode" screens in the Terminal Server install sequence.

Click here to contact Telecom Support Resources