4.14. Configuring the H.323 IP Stack

The H.323 IP stack is applicable to DM3 IPLink T-1 and E-1 boards that contain a network interface card (NIC). There are two ways to use the H.323 IP stack: embedded or host-based. To use the embedded stack, select PCD/FCD files prefaced with ipt . To use the host-based stack, select PCD/FCD files prefaced with ipvs.

Note: The procedure for selecting the PCD/FCD files the first time you run DCM is described in Section 4.2, Selecting the DM3 Configuration Files. If you have already selected PCD/FCD files and need to select a new set of files, refer to Section 4.10, Selecting Different DM3 Configuration Files.

In addition to selecting the appropriate PCD/FCD files (filenames prefaced with ipt), refer to the following procedures:

• Modify the Embedded H.323 IP Stack Configuration File (config.val)
• Run the Embedded H.323 Stack Configuration Utility (IPTConf.exe)

For more information about developing or porting application using the H.323 stack, refer to the following documents supplied with this release:

• Global Call IP over Embedded Stack Technology User's Guide for Linux and Windows
• Global Call IP over Host-Based Stack Technology User's Guide for Linux and Windows
• Porting Global Call H.323 Applications from Embedded Stack to Host-Based Stack Application Note.

Click here to contact Telecom Support Resources