4. Configuration Procedures

The following information provides detailed procedures for each major step in the configuration process (some steps may not apply to your configuration):

1. Starting the Intel Dialogic Configuration Manager (DCM)
2. Selecting the DM3 Configuration Files
3. Configuring and Installing Hardware Configurable Boards
4. Designating the Clock Source
5. Setting the Encoding Method for DM3 E-1 Applications
6. Configuring Digital Network Interface Parameters (Springware Boards)
7. Adjusting Voice Parameters (Springware Boards)
8. Configuring DM3 IPLink Network Interface Connector
9. Modifying Other DCM Property Sheet Parameters
10. Selecting Different DM3 Configuration Files
11. Verifying Device Names
12. Installing the BRI/2 ISDN Network Adapter Driver
13. Reserving TDM Bus Resources for Third Party Devices
14. Configuring the H.323 IP Stack

For an overview of the process, see Section 1.2, Configuration Procedures.

Note: To use DCM, you must have administrative privileges on your local computer and on any remote computer you connect to. Contact your network administrator to set up administrative privileges as required.

Click here to contact Telecom Support Resources