2.3. Saving Existing Configuration Data

If you want to save existing configuration data from a previous release of the Intel Dialogic System Software, follow these steps:

1. Identify the directories containing the following files (the default location is \Program Files\Dialogic\Data):
   • *.prm
   • *.config
   • *.fcd
2. Copy the files you located in step 1 to a disk or to any directory that is not a subdirectory of the Intel Dialogic installation directory (the default installation directory is \Program Files\Dialogic).
3. If an old version of the System Software is installed on your system, uninstall it according to the procedures in Section 2.4, Uninstalling the Previous Version of the Software.
4. Install the new release of the Intel Dialogic System Software according to Section 2.5, Installing Intel Dialogic System Release 5.1.1 Software.

   Note: Do not run DCM until you complete the rest of this procedure.

5. Copy the files you preserved in step 2 above to the corresponding subdirectories in the new installation.

   The procedure for integrating previous board configuration data with DCM is now complete.

Continue the configuration process with Chapter 4, Configuration Procedures, which describes the use of DCM.

Click here to contact Telecom Support Resources