3.1. Saving Existing Configuration Data

If you want to save existing configuration data, follow these steps:

1. Identify the directories containing the following files (the default location is \Program Files\Dialogic\Data):
   • *.prm
   • *.config
   • *.fcd
2. Copy the files you located in step 1 to a disk or to any directory that is not a subdirectory of the Intel Dialogic installation directory (the default is \Program Files\Dialogic).
3. Document any DCM settings you want to preserve.
4. Install Feature Pack 1 according to Section 3.2, Installing Feature Pack 1.

   Note: Do not run DCM until you complete the rest of this procedure.

5. Copy the configuration files you preserved in step 2 to the corresponding subdirectories in the new installation.
6. Proceed with Chapter 4, Configuration Procedures, which describes the use of DCM. Reset the DCM configuration settings preserved in in step 3 by following the procedure described inSection 4.9, Modifying Other DCM Property Sheet Parameters .

Click here to contact Telecom Support Resources