2.1.3. Selecting the Slot Location in the Chassis

Be sure that your chassis has enough slots for each of the boards that you intend to install. Some boards (with daughterboards) require two slots to accommodate the extra width of the daughterboard(s).

With mixed H.100 (CT Bus)/SCbus systems, the location of boards within the chassis can be significant. For a discussion of hardware configuration in mixed systems, refer to Section 2.1.4, Configuring a Mixed CT Bus/SCbus System.

After considering the slot location issues, you can configure and install BLT, PCI, and cPCI boards as described in Section 2.1.6, Configuring and Installing BLT, PCI, and cPCI Boards. The configuration and installation of hardware configurable boards is not done until after you've installed the Intel Dialogic System Software and started DCM. Instructions for this are given in Section 4.3, Configuring and Installing Hardware Configurable Boards.

Click here to contact Telecom Support Resources