4.3.  Downloading the Firmware - Windows

• 4.3.1.  Intel® NetStructure DM/IP Series Boards

• 4.3.2.  Intel® NetStructure IPT Series Boards

This section describes how to download the firmware on Windows systems. It describes the parameters that must be set before download.

4.3.1.  Intel® NetStructure DM/IP Series Boards

Follow the directions for installing and configuring the DM/IP board in the Software Installation Guide for your system release and the Configuration Guide for your board. The following parameters should be set in the Intel® Dialogic Configuration Manager (DCM) for the IP Mail demo to work properly:

• PCD/FCD Files

 
Identify a PCD and corresponding FCD file that matches your configuration. Make sure to select a file that starts with ipvs_evr, in order to support the voice resources needed for the voice mail application. The PCD files supplied with the release are described in the Configuration Guide for your board.

• IP Address
  1. Select the Network tab.
  2. Enter the IP address of the NIC on the DM/IP board in the IPAddress field.
  3. Enter the Gateway IP address in the Gateway IPAddress field. This address should match the segment in the IPAddress field, ending with 250 (xxx.xxx.xxx.250).
  4. Click on the Start Service button to start the download.

4.3.2.  Intel® NetStructure IPT Series Boards

At the time of writing this document, there are no special instructions for downloading the firmware. Refer to the Software Installation Guide for your system release and the Configuration Guide for your board for details on installing and downloading the firmware.

Click here to contact Telecom Support Resources