2.1 Assumptions and Prerequisites

Before you can stop and restart the Intel Dialogic system, Intel Dialogic boards, and Intel NetStructure boards using the SNMP agent software, you must do the following:

• Install and configure Windows SNMP service. (Refer to Section 1.2, "Preparing to Use the SNMP Agent Software".)
• Install the Intel Dialogic system release software (refer to the Intel Dialogic system release software installation and configuration guide).
• Configure all the boards in the system (refer to the Intel Dialogic system release software installation and configuration guide).
• To start the Intel Dialogic system service using the SNMP agent software, you need to perform a one-time local startup of the Intel Dialogic system service on the managed node. Starting the Intel Dialogic system service results in downloading firmware with configuration parameter settings and initiating the host device drivers.

  Once you have started the Intel Dialogic system service, the Intel Dialogic system service can be stopped or started from the network management node.

Notes:

1. For information about starting the Intel Dialogic System for the first time, starting the Intel Dialogic System after initial startup, and stopping the system (without the use of SNMP), refer to the administration chapter in the installation and configuration guide for the system release software.
2. For additional information about the Intel Dialogic Configuration Manager (DCM) and the Intel Dialogic system service, consult the DCM online help by pressing F1 when the DCM Main window is active.

Click here to contact Telecom Support Resources