RAID Manager pair command results
To avoid getting mixed results, run RAID Manager commands on pairs that are in the required status.
The following table shows the results of running commands on pairs depending on their status.
|
Status |
RAID Manager command | ||||||
|
paircreate |
paircreate -split |
pairsplit |
pairresync |
pairresync -restore |
pairsplit -S |
pairsplit -E | |
|
SMPL |
Ok |
Ab |
Ab |
Ab |
Ab |
Np |
Ab |
|
COPY |
Np |
Ab |
Ab |
Np |
Np |
Ab |
Ab |
|
PAIR/PFUL |
Np |
Ok |
Ok |
Np |
Np |
Ok |
Ab |
|
PSUS/PFUS |
Ab |
Np |
Np |
Ok |
Ok |
Ok |
Ab |
|
RCPY |
Np |
Ab |
Ab |
Np |
Np |
Ab |
Ab |
|
PSUE |
Ab |
Ab |
Ab |
Ok |
Ab |
Ok |
Ab |
|
Legend:
| |||||||
Do not specify noread mode (-m noread) for S-VOLs using RAID Manager. If you do, the command ends normally but the noread mode does not take effect.
If a RAID Manager command is rejected and ends abnormally and the host is running the HP-UX operating system, sense bytes (SSB) are output to the RAID Manager error log file. Sense bytes indicate the cause of the error.