0x0b27

The command cannot be executed because the virtual LDEV is not defined.

Define the virtual LDEV and then execute the command.

0x2c3a

Because the specified volume was being enabled for the attribute of the data direct mapping, the operation was rejected.

Specify the volume of which the attribute of the data direct mapping is disabled.

0x2c77

Because the specified DP-VOL was a deduplication system data volume, the operation was rejected.

Specify a DP-VOL that is not a deduplication system data volume.

0x2c78

Because the specified DP-VOL is being deleted, the operation failed.

Specify a DP-VOL that is not being deleted.

0x9100

The command cannot be executed because user authentication is not performed.

Perform user authentication.

0xb900/ 0xb901/ 0xaf28

Error occurred when increasing DP-VOL capacity operation.

Ask Hitachi Solution Support Center to solve the problem.

0xb902

The operation was rejected because the configuration was being changed by SVP or Hitachi Device Manager - Storage Navigator, or because the DP-VOL capacity was going to be increased by another instance of the RAID Manager.

Increase the DP-VOL capacity after finishing operations on your storage system, such as the Virtual LUN operation or a maintenance operation. .

0xb903

The operation cannot be performed because the specified resource is contained in NAS_Platform_System_RSG.

Move the specified resource to a resource group other than NAS_Platform_System_RSG.

0xaf22

The operation was rejected because the specified volume is placed online with the OS which does not support EAV (Extended Address Volume).

Increase the DP-VOL capacity after the specified volume is placed online with the OS which supports EAV.

0xaf24

The operation was rejected because the total DP-VOL capacity exceeded the pool reservation rate after the capacity was increased.

Specify a capacity so that the pool reservation rate will not be exceeded.

0xaf25

The operation to increase capacity cannot be performed on the specified DP-VOL.

Check the emulation type of the specified DP-VOL.

0xaf26

The operation was rejected because of lack of cache management devices due to increased capacity.

Specify a capacity so that the maximum number of cache management devices will not be exceeded.

0xaf29

Because the specified volume was not a DP-VOL, the operation was rejected.

Makes sure that the volume is a DP-VOL.

0xaf2a

Because the specified capacities are invalid or exceeded the value immediately below LDEV Capacity in the Expand Virtual Volumes window, the operation was rejected.

To increase capacity, specify the correct capacity that does not exceed the value immediately below LDEV Capacity in the Expand Virtual Volumes window.

0xaf2b

Because the specified volume operation was not finished, the operation was rejected.

Re-execute the operation after a brief interval.

0xaf2c

Because the shared memory capacity is not enough to increase the specified capacity, the operation was rejected.

Confirm the value immediately below LDEV Capacity in the Expand Virtual Volumes window.

0xaf2e

Because the specified DP-VOL was used by other software or was being formatted, the operation was rejected.

Wait until formatting of the specified volume is finished, or see Using Dynamic Provisioning or Dynamic Tiering or active flash with other software products and confirm whether the DP-VOL is used with software in which that the DP-VOL capacity cannot be increased.

0xaf2f

Because the configuration of journal volumes is being changed, the specified DP-VOL capacity cannot be expanded.

Re-execute the operation after the journal volume configuration is changed.

0x0b2b

Because the raidcom extend ldev command was executed with specifying the -cylinder option to the DP-VOL for the open system, the operation was rejected.

Re-execute the raidcom extend ldev command without specifying the -cylinder option.