Setting advanced system settings
You can change settings about alert display and data acquisition by setting advanced system settings. Log off and log in again when you enabled or disabled an advanced system setting.
Prerequisites
You must have the Storage Administrator (Initial Configuration) role to perform this task.
Procedure
Click Settings > Environmental Settings > Edit Advanced System Settings.
Select the advanced system setting to set and click Enable.
Hide alert information. If you enable this advanced system setting, the Alert window in the Device Manager - Storage Navigator main window does not open.
Refresh forcibly after Apply. If you enable this advanced system setting, after settings changes are applied to the storage system, the configuration information for the storage system is forcibly updated.
Disable data polling. If you enable this advanced system setting, polling stops.
Disable retry of data updating. If you enable this advanced system setting, retry does not occur even if data cannot be acquired.
Enable Device Manager - Storage Navigator 2 All Function. If you enable this advanced system setting, the restrictions on login from Device Manager - Storage Navigator's login window are cleared, including the restrictions on the users who can log in and on the functions available after login. When enabling or disabling the advanced system setting, log in again.
Click Finish. The Confirm window opens.
In the Confirm window, check the settings and enter a task name in Task Name.
Click Apply. The task is registered. If the Go to tasks window for status check box is checked, the Task window opens.
Related Topics