ENTITYTRAP_1.3.6.1.4.1.2011.5.25.219.2.2.3 hwBoardFail

Description

ENTITYTRAP/2/BOARDFAIL: OID [oid] Board become failure for some reason.(Index=[INTEGER], EntityPhysicalIndex=[INTEGER], PhysicalName="[OCTET]", EntityTrapEntType= [INTEGER], EntityTrapFaultID=[INTEGER], EntityTrapReasonDescr="[OCTET]")

Some functions on the board are invalid.

Attribute

Alarm ID	Alarm Severity	Alarm Type
1.3.6.1.4.1.2011.5.25.219.2.2.3	Major	equipmentAlarm(5)

Parameters

Name	Meaning
OID	Indicates the ID of a MIB object.
Index	Indicates the entity index.
EntityPhysicalIndex	Indicates the physical entity index.
PhysicalName	Indicates the name of the physical entity.
EntityTrapEntType	Indicates the type of the physical entity, such as mpu(1), and lpu(2).
EntityTrapFaultID	Indicates the error code.
EntityTrapReasonDescr	Indicates the description of the alarm cause.

Impact on the System

The board is unavailable or some services are interrupted.

Possible Causes

Error Code	Possible Cause
132865	The RTC was abnormal. NOTE: When the RTC is faulty, the system time may be incorrect after the device is restarted. However, services indifferent to system timing are not affected. If a NTP server is available on the network, the system time will be corrected after you enable the NTP client function on the device.
2125827	The temperature sensor is abnormal.
132121	The current on the USB flash drive exceeds the upper limit.
132149	The bad block rate for the NAND flash exceeds the threshold.
132616	The CPLD clock is faulty.
132618	The NP chip is faulty.

Procedure

Check whether the faulty board is registered successfully and services are running properly.
Run the display device command to check whether the faulty board is registered successfully, and run the display interface command to view the statistics on received and sent packets. According to the statistics, check whether services are running properly.
- If the faulty board is registered successfully and services are running properly, no action is required.
- If the faulty board is unregistered or services are not running properly, go to step 2.
If the faulty board is a main control board, run the reboot command to reboot the device. Then check whether the device is working properly.
- If the board can be registered successfully and services are running properly, no action is required.
- If the board cannot be registered or services cannot run properly, the board hardware is faulty. Replace this board.
- If the fault persists, go to step 3.
Contact technical support personnel.

Related Information

ENTITYTRAP_1.3.6.1.4.1.2011.5.25.219.2.2.4 hwBoardFailResume