L2IFPPI_1.3.6.1.4.1.2011.5.25.160.3.1 hwMflpIfBlock

Description

L2IFPPI/4/MFLPIFBLOCK:OID [OID] Loop exist in vlan [INTEGER], Interface [OCTET] blocked, block-time is [GAUGE] for [OCTET], Mac Address is [OCTET].

MAC address flapping occurs and the interface is blocked.

Attribute

Alarm ID Alarm Severity Alarm Type
1.3.6.1.4.1.2011.5.25.160.3.1 Warning equipmentAlarm(5)

Parameters

Name Meaning
oid Indicates the ID of the MIB object.
INTEGER Indicates the VLAN ID.
OCTET1 Indicates the blocked interface name.
GAUGE Indicates the time when the interface is blocked.
OCTET3 Indicates the flapped MAC address.
OCTET2 Indicates the cause why the interface is blocked.

Impact on the System

Traffic cannot be received normally.

Possible Causes

Cause 1: The interfaces where loops occur are added to the same VLAN.

Cause 2: Cables are connected incorrectly.

Cause 3: Loop detection and STP are enabled to remove loops on the network.

Procedure

  1. Check that cables are connected correctly. Then check whether the alarm is still reported.

    • If yes, go to step 2.
    • If not, go to step 9.

  2. Check whether the two interfaces that learn the same MAC address can be added to different VLANs according to the networking.

    • If yes, go to step 3.
    • If not, go to step 4.

  3. Modify the configuration and add the two interfaces that learn the same MAC address to different VLANs. Then check whether the alarm is still reported.

    • If yes, go to step 4.
    • If not, go to step 9.

  4. Check whether the ring network meets requirements.

    • If yes, go to step 7.
    • If not, go to step 5.

  5. Do as follows to remove loops:

    1. Run the display loop-detect eth-loop [ vlan vlan-id ] command to view the blocked interface.
    2. Run the display mac-address vlan vlan-id command to search an interface that learns the MAC address.
    3. Shut down one interface according to the networking.
    4. Run the reset loop-detect eth-loop vlan vlan-id { all | interface interface-type interface-number | mac-address mac-address } command to delete the blocked interface.

  6. Check whether the traffic transmission is normal.

    • If yes, go to step 9.
    • If not, go to step 7.

  7. Disable loop detection and enable STP. Then check whether the alarm is still reported.

    • If yes, go to step 8.
    • If not, go to step 9.

  8. Contact technical support personnel.
  9. End.

Related Information

L2IFPPI_1.3.6.1.4.1.2011.5.25.160.3.2 hwMflpIfResume

Parent Topic: L2IFPPI
Copyright © Huawei Technologies Co., Ltd.
< Previous topic Next topic >