Protocol Traffic Distribution

Function

The protocol traffic distribution chart shows the proportion of the TCP, UDP, ICMP, and other traffic. You can view the distribution of the inbound and outbound traffic of the cleaning device, and the distribution of the detected traffic of the detecting device.

Parameter

**Table 1** Query parameters of protocol traffic distribution
Parameter	Description
Device	Select a device from the drop-down list. Total Cleaning and Total Detecting are described as follows: Total (Cleaning): Indicates that traffic on all cleaning devices is queried. Total (Detecting): If two or more detecting devices in a defense group work in Load Redundancy mode, the maximum traffic volume in the defense group is queried and the sum of traffic volumes among defense groups is queried. If two or more detecting devices in each defense group work in Load Balancing mode, the sum of traffic volumes within each defense group and among defense groups is queried.
Zone	Click , select a Zone on the Zone page that is displayed, and then click OK.
IP Address	Enter the destination IP address. Both IPv4 and IPv6 addresses are applicable. Traffic destined for the IP address is queried.
Time	Click to select the start time and end time of statistics. Or you can change the time values in corresponding text boxes. The end time should be later than the start time and the interval cannot be longer than one year. If the query interval is longer than or equal to seven days and shorter than one year, statistics are collected daily. If the query interval is longer than or equal to one day and shorter than seven days, statistics are collected hourly. If the query interval is shorter than one day, statistics are collected every five minutes.
Unit	Select a traffic measurement unit. The unit can be pps or kbps. The default unit is pps.

Example

If the device is set to Total (Cleaning) and the Zone to Total, traffic distribution within a period of time is displayed in Figure 1.

Figure 1 Protocol traffic distribution

Procedure

Choose Report > Report > Traffic Analysis.
Click the Protocol Traffic Distribution tab.
Set query parameters. For details, see Table 1.
Click Search.
Traffic distribution that meets query conditions is displayed.
Optional: Open or save the query results as files, or send queried reports to the specified email address.
- Click to open or save the query results as PDF files. A maximum of 10,000 entries can be displayed.
- Click to open or save the query results as EXCEL files. A maximum of 10,000 entries can be displayed.
- Click to open or save the query results as CSV files. All data except figures can be displayed.
- Click to enter a recipient mail address and select an attachment format. Then click OK.