When the SIG1000E/9280E serves as a detecting device, add the Service Analysis Server (SAS) to the ATIC Management center. To enable the ATIC Management center to synchronize Zones on the SIG1000E/9280E, configure the SIG1000E/9280E database of the SAS on the ATIC Management center. Ensure that the configured database is the same as the SIG1000E/9280E database on the SAS.
Prerequisites
Before you create an SAS, ensure that the following are available:
- IP addresses of devices
- SIG1000E/9280E database on the SAS
- IP connectivity between the ATIC management center and the device
Context
The Service Analyse Server (SAS) is the service processing center of the SIG1000E/9280E system. It is responsible for receiving and analyzing service information reported by the SRS, and saving the information to the database. ATIC Management center needs to synchronize the Zone on the SIG1000E/9280E device using the SAS database.
Procedure
- Choose .
- Click
.
- In the Basic Information group box,
set the name and IP address of an device and select SIG
SAS for Device Type.
- Configure the parameters. For details, see Table 1,
Table 1 Configuring the database information of the SAS Parameter Description Value Database IP Address Indicates the database information of the SAS. The passwords must meet the minimum complexity requirement. That is, the passwords must contain at least three of the following, including upper-case letters (A to Z), lower-case letters (a to z), digits (0 to 9), and special characters (such as !, #, $, and %). You must change the passwords periodically.
The configured database must be the same as the SIG1000E/9280E database on the SAS. Database username Database password Areas to Be Synchronized The Zones on the SIG1000E/9280E device in the selected areas are to be synchronized to the ATIC Management center. You can select all areas or specify some of the areas.
- All: Indicates all the configured areas on the SIG1000E/9280E device. If the number of areas configured on the SIG1000E/9280E device increases, the number of synchronized areas increases accordingly.
- Specified areas: Indicates that only the Zone in specified areas on the SIG1000E/9280E device are to be synchronized.
- Click OK.