Storm Control

Context

To limit the rate of broadcast, unknown multicast, or unknown unicast packets on inbound interfaces and prevent heavy traffic on a device, configure storm control for the corresponding types of packet on the inbound interface.

Procedure

Choose Configuration > Security Services > Storm Control and click the Storm Control tab.
Select a port to be configured. Perform the following operations as required in the port area:
- Click a port icon. To deselect the port, click the port icon again.
- Drag the cursor to select consecutive ports in a batch.
- Click multiple port icons to select these ports, and click a port icon again to deselect the port.
- Select a slot where a panel is located. All ports on the panel are selected.
Turn on Storm Control and enable log or alarm for the storm control.
By default, log and alarm for the storm control are disabled.
Configure storm control for broadcast packets received on the selected interface in Broadcast control threshold (pps).
- Upper threshold: specifies the upper limit in pps mode.
- Lower threshold: specifies the lower limit in pps mode.
Configure storm control for unknown multicast packets received on the selected interface in Multicast control threshold (pps).
- Upper threshold: specifies the upper limit in pps mode.
- Lower threshold: specifies the lower limit in pps mode.
Configure storm control for unknown unicast packets received on the selected interface in Unicast control threshold (pps).
- Upper threshold: specifies the upper limit in pps mode.
- Lower threshold: specifies the lower limit in pps mode.
Set the storm control action in Storm control action.
- None: indicates that no storm control action is configured.
- Disable: indicates to shut down the interface.
- Block: indicates to discard packets.
Click Apply to complete the configuration.