Connect to Router

You can configure functions of interfaces on switches that are connected to routers on the GUI.

If the device cannot be connected to a router, this page is hidden.

If the switch does not support the MEth port, click Configuration > Basic Services > Interface Settings to access the configuration page.

Choose Configuration > Basic Services > Interface Settings > Service Interface Setting. Click Connect to Router.
Click an interface icon to select an interface. You can select only one interface at one time.

Set parameters on the Configure Interface.

Table 1 describes the parameters on the Configure Interface.

**Table 1** Parameters on the **Configure Interface**
Item	Description
Interface Status	Set the interface status. ON: The current interface is enabled. OFF: The current interface is disabled.
IPv4 Address/Mask	Configure an IPv4 address and a subnet mask for the current interface.
IPv6 Address/Prefix Length	Configure an IPv6 address and a prefix length for the current interface.
MTU(bytes)	Configure the MTU for the current interface. The value ranges from 128 to 9216, in bytes. The default value is 1500.