Network-Side Service

Procedure

• Create network side VLANs and IP addresses.
  1. Choose Configuration > SVF Quick Config > Network-Side Service and click the Network-Side VLAN and IP tab.
  2. Click Create and set parameters.

  3. Set VLAN ID and VLANIF IP Address/Mask, select OSPF Status, and click Manage to select Member Interfaces and set Function Description.
  4. Click to complete the configuration.
• Delete network-side VLANs and IP addresses.
  1. Choose Configuration > SVF Quick Config > Network-Side Service and click the Network-Side VLAN and IP tab.
  2. Select the network-side VLAN and IP address to be deleted and click Delete.
  3. In the dialog box that is displayed, click OK.
• Create routes.
  1. Choose Configuration > SVF Quick Config > Network-Side Service and click the Route tab,

  2. Click Create. The Create Static Route page is displayed.
     Table 1 describes the parameters on the page.

     Table 1 Parameters on the Create Static Route

     Item	Description
     Destination IP	Identifies the destination IP address or destination network of IP packets, for example, 10.10.10.1.
     Subnet mask	Used with a destination IP address to identify the address of the network segment where the destination host or device resides. The address of the network segment where the destination host or device resides can be calculated according to the AND operation on the destination address and network mask, for example, 255.255.0.0.
     Next hop address	Indicates the next-hop destination address or destination network of IP packets, for example, 10.10.10.2. NOTE: Either the next hop or outbound interface must be specified.
     Outbound interface	Indicates through which interface IP packets will be forwarded.
     Priority	Indicates the route priority. There may be multiple routes to the same destination. These routes may be dynamic routes discovered by different routing protocols or static routes manually configured. A route with the highest priority (the smallest value) becomes the optimal route.
     Description	Indicates the description of a created route.

  3. Configure the parameters.
  4. Click OK to complete the configuration.
• Delete routes.
  1. Choose Configuration > SVF Quick Config > Network-Side Service and click the Route tab.
  2. Select the route to be deleted and click Delete.
  3. In the dialog box that is displayed, click OK.