Radio Calibration

Configure manual calibration.

Choose Configuration > Wireless Services > AC Config > Radio Calibration. The Radio Calibration page is displayed.
Set Calibration mode to Manual.

Set calibration parameters. Table 1 describes the calibration parameters.

**Table 1** Calibration parameters
Parameter	Description
Calibration policy	Calibration policy. Rogue AP When rogue APs (rogue APs cannot be controlled by an AC) exist on a network, set the radio calibration policy to Rogue-ap. The device then implements radio calibration to minimize the rogue AP interference on the entire network. Load When an AP is heavily loaded, set the radio calibration policy to Load. The device then preferentially allocates channels with a little interference to the heavily loaded APs. Non-Wi-Fi When non-Wi-Fi devices exist on a network, set the radio calibration policy to Non-wifi. The device then implements radio calibration to reduce interference of non-Wi-Fi devices on the network.
Calibration sensitivity	Configure radio calibration sensitivity. There are three levels of radio calibration sensitivity: Low Medium High
Start time	Specifies the start time for radio calibration in automatic mode.
Calibration interval(min)	Specifies the radio calibration interval in auto mode.

Configure automatic calibration.
1. Choose Configuration > Wireless Services > AC Config > Radio Calibration. The Radio Calibration page is displayed.
2. Set Calibrate mode to Auto and specify Calibration interval(min) and Start time. You can also click Start to trigger the calibration.
3. Set calibration parameters. Table 1 describes the calibration parameters.
4. Click Apply. In the Info dialog box that is displayed, click OK.
Configure scheduled calibration.
1. Choose Configuration > Wireless Services > AC Config > Radio Calibration. The Radio Calibration page is displayed.
2. Set Calibrate mode to Scheduled and specify Start time. You can also click Start to trigger the calibration.
3. Set calibration parameters. Table 1 describes the calibration parameters.
4. Click Apply. In the Info dialog box that is displayed, click OK.