Traffic Behavior

Procedure

• Create a traffic behavior.
  1. Choose QoS > Traffic Management > Traffic Behavior in the navigation tree to access the Traffic Behavior page.
  2. Click Create to access the Create Traffic Behavior page.

     Table 1 describes the parameters on the Create Traffic Behavior page.

     Table 1 Create Traffic Behavior

     Parameter			Description
     Traffic behavior name			Indicates the name of a traffic behavior. This parameter is mandatory.
     Action			Indicates the traffic action used to control packets. The action can be deny, permit or none. By default, the action is none.
     Traffic statistics			Indicates whether to enable the traffic statistics. The value can be Enabled or Disabled. By default, the value is Disabled.
     Configure Traffic Policing	CIR		Indicates the CIR, which is the allowed rate at which traffic can pass through.
     	PIR		Indicates the PIR, which is the peak rate at which traffic can pass through. NOTE: The value of PIR cannot be smaller than the value of CIR. By default, the value of PIR is equal to the value of the CIR.
     	CBS		Specifies the committed burst size (CBS), which is the average volume of burst traffic that can pass through an interface.
     	PBS		Specifies the peak burst size (PBS), which is the maximum volume of burst traffic that can pass through an interface. NOTE: The default value of PBS is related to the value of PIR.
     	Green packets	Green packets	Indicates whether green packets are allowed to pass through. The action can be Pass or Discard. By default, the action is Pass.
     		Service class	Indicates the service class.
     	Yellow packets	Yellow packets	Indicates whether yellow packets are allowed to pass through. The action can be Pass or Discard. By default, the action is Pass.
     		Service class	Indicates the service class.
     	Red packets	Red packets	Indicates whether red packets are allowed to pass through. The action can be Pass or Discard. By default, the action is Discard.
     		Service class	Indicates the service class.
     Configure Re-mark Action	802.1p priority		Indicates the 802.1p priority.
     	Local priority		Indicates the local priority. NOTE: You cannot set both the 802.1p priority and the local priority for redirection in a traffic behavior.
     	DSCP priority		Indicates the DSCP priority.
     	Destination MAC		Indicates the destination MAC address. The value is in the format H-H-H. Each H represents four hexadecimal digits.
     	VLAN ID		Indicates the VLAN ID.
     	Inner VLAN		Indicates the inner VLAN ID.
     Configure Redirection Action	Redirect to interface		Indicates the interface where packets are redirected, for example, GigabitEthernet1/0/1.
     	Redirect to next hop IP		Indicates the next hop address where packets are redirected, for example, 10.10.10.1. NOTE: You cannot configure both the next hop address where packets are redirected and the re-marked destination MAC address.
     	CPU		Indicates that packets are redirected to the CPU.

  3. Set parameters.
     NOTE:

     To delete configuration of an item, deselect the check box of the item.

  4. Click OK.
• Modify a traffic behavior.
  1. Choose QoS > Traffic Management > Traffic Behavior in the navigation tree to access the Traffic Behavior page.
  2. Click to open the Modify Traffic Behavior page.
     NOTE:

     The traffic classifier name cannot be modified.

  3. Set parameters.
  4. Click OK.
• Delete a traffic behavior.
  1. Choose QoS > Traffic Management > Traffic Behavior in the navigation tree to access the Traffic Behavior page.
  2. Select a record that you want to delete and click Delete. The system asks you whether to delete the record.
  3. Click OK.