Port Loopback Test

Procedure

1. Choose Configuration > Basic Services > Interface Settings > Service Interface Setting.Select Port Loopback Test.

2. Select the interface that you want to configure. Perform either of the following operations as required.
   • Click an interface icon to select an interface.
   • Drag the mouse to select multiple consecutive interfaces in a batch.
   • Click multiple port icons to select these ports, and click a port icon again to deselect the port.
   • Select an interface card name to select all the interfaces on the interface card.

3. Click Apply. In the dialog box that is displayed, click OK.
4. The returned information is displayed in Configure Interface.

   Table 1 describes parameters on the displayed page.

   Table 1 Interface parameter list

   Parameter	Description
   Interface	Indicates the type and number of the interface where a loopback test is performed.
   Management Status	Indicates the management status. Down: indicates that the interface is disabled. Up: indicates that the interface is enabled. Shutdown: indicates that the shutdown command has been run on the interface.
   Detection Result	Indicates the loopback test result.