Checking the Status of a Disk

Procedure

1. On the CLI, run the show disk general command to check whether the Health Status is Normal.

   

   • If yes, no further action is required.
   • If no, go to step 2.

2. Check whether the Health Status is Fault.
   • If yes, go to step 3.
   • If no, go to step 4.

3. Use the FRU tool to replace the faulty disk and perform the check again to observe whether the check item fails.
   • If yes, go to step 4.
   • If no, no further action is required.

4. Check whether the Health Status is Pre-Fail.
   • If yes, go to step 5.
   • If no, go to step 7.

5. Check whether Role is Member Disk to determine a member disk.
   • If yes, go to step 6.
   • If no, use the FRU tool to replace the disk.

6. A precopying process will automatically start. Use the FRU tool to replace the disk after the disk precopy is complete. Then check whether the alarm is cleared.
   • If yes, no further action is required.
   • If no, go to step 7.

7. Collect related information and contact technical support engineers.