Checking the Status of a Disk

Procedure

1. On the CLI, run the show disk general command to check whether the Health Status is Normal.

   

   • If yes, no further action is required.
   • If no, go to step 2.

2. Check whether the Health Status is Fault.
   • If yes, go to step 3.
   • If no, go to step 4.

3. Replace the faulty disk and perform the check again to observe whether the check item fails.
   NOTE:

   For details about how to replace a disk module

   • 18500 V3&18800 V3, see section Replacing a Disk Module in the OceanStor 18500 V3&18800 V3 Product Documentation. The method used to replace disk modules is the same for V300R003 and V300R005. V300R003 is used as an example to describe how to replace a disk, see Replacing a Disk Module (24-Slot) and Replacing a Disk Module (25-Slot).
   • 2200 V3&2600 V3&5300 V3&5500 V3&5600 V3&5800 V3&6800 V3, see section Replacing a Disk Module in the OceanStor 5300 V3&5500 V3&5600 V3&5800 V3&6800 V3 Product Documentation or OceanStor 2200 V3&2600 V3&5300 V3&5500 V3&5600 V3&5800 V3&6800 V3 Product Documentation. The method used to replace disk modules is the same for V300R003 and V300R005. V300R003 is used as an example to describe how to replace a disk, see
     • 2U Controller Enclosure Replacing a Disk Module (12-Slot) and Replacing a Disk Module (25-Slot).
     • Disk Enclosure Replacing a Disk Module (24-Slot) and Replacing a Disk Module (25-Slot).
     • High-Density Disk Enclosure Replacing a Disk Module (12-Slot).
   • Dorado5000 V3&Dorado6000 V3, see section Replacing a Disk Module in the OceanStor Dorado5000 V3&Dorado6000 V3 Product Documentation.
   • If yes, go to step 4.
   • If no, no further action is required.

4. Check whether the Health Status is Pre-Fail.
   • If yes, go to step 5.
   • If no, go to step 7.

5. Check whether Role is Member Disk to determine a member disk.
   • If yes, go to step 6.
   • If no, replace the disk.

6. A precopying process will automatically start. Replace the disk after the disk precopy is complete. Then check whether the alarm is cleared.
   • If yes, no further action is required.
   • If no, go to step 7.

7. Collect related information and contact technical support engineers.