Checking the Health Degree of a Disk

Procedure

1. On the CLI, run the show disk health command to check whether the Health Mark is less than or equal to 60.

   

   • If yes, go to step 2.
   • If no, no further action is required.

2. Replace the faulty disk and perform the check again to observe whether the check item fails.
   NOTE:

   For details about how to replace a disk module

   • 18500 V3&18800 V3, see section Replacing a Disk Module in the OceanStor 18500 V3&18800 V3 Mission Critical Storage System V300R003 Product Documentation, see Replacing a Disk Module (24-Slot) and Replacing a Disk Module (25-Slot).
   • 2200 V3&2600 V3&5300 V3&5500 V3&5600 V3&5800 V3&6800 V3, see section Replacing a Disk Module in the OceanStor 5300 V3&5500 V3&5600 V3&5800 V3&6800 V3 Storage System V300R003 Product Documentation or OceanStor 2200 V3&2600 V3 Storage System V300R005 Product Documentation. The method used to replace disk modules is the same for V300R003 and V300R005. V300R003 is used as an example to describe how to replace a disk, see
     • 2U Controller Enclosure Replacing a Disk Module (12-Slot) and Replacing a Disk Module (25-Slot).
     • Disk Enclosure Replacing a Disk Module (24-Slot) and Replacing a Disk Module (25-Slot).
     • High-Density Disk Enclosure Replacing a Disk Module.
   • If yes, go to step 3.
   • If no, no further action is required.

3. Collect related information and contact technical support engineers.