Performing Planned Failback of Services in the Remote DR Center

After services are migrated from an HyperMetro data center to the remote DR center through planned migration, the services must be migrated back to the HyperMetro data center based on a DR testing plan.

Prerequisites

Planned migration and reprotection have been successfully performed for service systems according to a recovery plan.
The production hosts are working properly and the service system in the original production center is in the standby state.

Procedure

In HyperMetro (SAN) and asynchronous replication (SAN) scenarios, you can use UltraVR to migrate back services as follows:
1. On UltraVR in the remote DR center, select a recovery plan used to perform a failback, test the recovery plan, and clear data generated during the test.
  Before services are migrated back, perform a DR test to verify data availability to ensure service failback success rate. After the test, clear test data to avoid failback failures caused by the test data. For details, see DR Testing.
2. On UltraVR in the remote DR center, select the recovery plan to perform a planned migration.
  Migrate services back to the HyperMetro data centers. After the migration, check the data. For details, see 1 to 2 in Performing Planned Service Migration from an HyperMetro Data Center to the Remote DR Center.
  - You can select Synchronize HyperMetro to enable HyperMetro synchronization.
  Figure 1 shows the state of data replication between storage arrays after the migration.
  
  Figure 1 Data replication after the migration
3. On UltraVR at the remote DR center, select the recovery plan and perform reprotection.
  After the planned migration is complete, application systems are working in HyperMetro data centers and protected groups become Invalid. To ensure that services migrated back to the original HyperMetro data centers can be recovered at the remote DR center after an event (planned or unplanned) happens, reprotection must be performed and the replication status from HyperMetro data centers to the remote DR center must be recovered to synchronize data generated at the HyperMetro data centers to the remote DR site and to ensure that services are protected. For details, see Step 4 to Step 5 in Performing Planned Service Migration from an HyperMetro Data Center to the Remote DR Center.
  
  Figure 2 shows the state of data replication between storage arrays after the reprotection.
  
  Figure 2 Data replication after the reprotection
4. Ensure that communication among sites is normal.
  1. Log in to the storage array management software at active data center B, and ensure that the status of the HyperMetro pair between active data center B and active data center A is normal and that asynchronous replication links between active data center B and site C are normal.
  2. Log in to UltraVR at active data center B, and ensure that status of HyperMetro (SAN) and asynchronous replication (SAN) protected groups is normal and the topology structure has been restored to the original networking status.