Configuring a Static Route for a Bond Port

Procedure

1. Choose Cluster > Network > Port and Route > Bond Port.
2. Select one or more desired ports and click Configure Static Route.

   The Configure Static Route page is displayed.

   

   You can also click More on the right of a desired port and select Manage Static Route. On the Manage Static Route page that is displayed, click Add to configure a static route.

3. Configure the static route information for a bond port.
   • Selecting New in Configuration Mode
     1. Set the parameters listed in Table 1.

        Table 1 Static route parameters

        Parameter	Description
        Destination IP Address	Indicates the IP address or network segment of the target node network port connected to the port.
        Mask/Prefix	Indicates the subnet mask or prefix of the network segment where the target node network port connected to the port resides.
        Gateway	Indicates the gateway where the local bond port's IP address resides.

     2. (Optional) Click Add to add another static route.
   • Selecting Copy from in Configuration Mode
     1. In Node, click Choose to select a node.
     2. In Port, click Choose to select a port.
     3. In the Available Static Routes list, select one or more required static routes.
     4. (Optional) Click More on the right of a desired route and select Modify to modify it.
        

        This operation does not change the route information of the source node.

4. Click OK.