Modifying Properties of a HyperMetro Consistency Group

Procedure

1. Choose Data Protection > Protection Entity > Protection Group > HyperMetro Consistency Group.
2. Click More on the right of a desired HyperMetro consistency group and select Modify.

   The Modify HyperMetro Consistency Group page is displayed on the right.

3. Modify the properties of the HyperMetro consistency group. Table 1 describes related parameters.

   Table 1 HyperMetro consistency group

   Parameter	Description
   Name	Name of the HyperMetro consistency group.
   Speed	data synchronization speed of the HyperMetro consistency group. The value ranges from 1 MB/s to 1024 MB/s (or 1024 KB/s to 1,048,576 KB/s). During initial synchronization, the recommended rate is 100 MB/s or higher. During incremental synchronization, if the service is busy, the recommended rate is 0 MB/s to 20 MB/s. During incremental synchronization, if the service load is heavy, the recommended rate is 20 MB/s to 70 MB/s. During incremental synchronization, if the service is idle, the recommended rate is 100 MB/s or higher. The default value is 32 MB/s.
   Recovery Policy	Whether the system automatically synchronizes data after a HyperMetro fault is rectified. Possible options are Automatic and Manual. Automatic: The previous ongoing tasks automatically resume immediately after the remote replication fault is rectified. Manual: The value of Running Status changes to To be synchronized after the remote replication fault is rectified. In this case, you can check the system and then determine whether to resume the previous ongoing tasks manually.

4. Click OK.