This section describes how to view basic information about created VXLANs.
Context
- On the VXLAN management page, click
to refresh VXLANs. - On the VXLAN management page, click
next to a parameter and enter a keyword to search for desired VXLANs. - On the VXLAN management page, click
and select desired VXLAN parameters to be viewed.
Procedure
- Choose Resources > Access > VXLAN.
- View the VXLANs in the function pane. Table 1 describes related parameters.
Table 1 VXLAN parameters Parameter
Description
Management IP Address
Management IP address of a storage node.
Status
VXLAN status. The value can be Running, Starting, Stopping, or Start/Stop failed.
NOTE:If the status is Start/Stop failed, check the VXLAN configuration of the node, remove the VXLAN, and add it again.
Health Check IP Address/Mask
IP address and mask configured on a storage node for checking the health status of the node. The IP address and mask are used for VPC EP2.0 load balancing.
Health Check Gateway
Gateway of the health check IP address.
Service IP Address/Mask
Service IP address and mask, to be used by an NFS/CIFS client to mount the file service.
VXLAN Tunnel IP Address/Mask
VTEP IP address used to establish a VXLAN tunnel between nodes. The VTEP IP addresses of the nodes can communicate with each other.
VXLAN Tunnel Gateway
Gateway corresponding to the VXLAN tunnel IP address.
VXLAN Tunnel VLAN ID
VLAN ID of the service plane.
Destack Networking
If the value is Yes, switches are not stacked. If the value is No, switches are stacked.
Click the management IP address of a storage node to view its basic VXLAN information.