Managing an IP Address Pool

Procedure

1. Choose Services > File Service > Service Network.
2. Click More on the right of the desired zone and select IP Address Pool.

   The IP Address Pool page is displayed.

3. Configure the IP address pool.
   • Adding an IP address
     1. Click Add.

        The Add IP Address page is displayed.

     2. Configure IP address information.

        Table 1 describes related parameters.

        Table 1 IP address parameters

        Parameter	Description
        Type	Indicates the IP address adding type. The value can be Single Address or Address Segment.
        IP Address/Mask	Modify the service IP address and subnet mask when Type is set to Single Address.
        Start IP Address/Mask	Modify the start service IP address and subnet mask when Type is set to Address Segment.
        End IP Address/Mask	Modify the end service IP address and subnet mask when Type is set to Address Segment. NOTE: A maximum of 50 IP addresses can be contained in an IP address segment.

     3. Click OK.
   • Removing an IP address
     Select one or more desired IP addresses and click Remove.

     

     You can also click More on the right of a desired IP address and select Remove.

4. Click Close.