Modifying HyperMetro Pair Properties

Automatic: The previous ongoing tasks automatically resume immediately after the remote replication fault is rectified.
Manual: The value of Running Status changes to To be recovered after the remote replication fault is rectified. In this case, you can check the system and then determine whether to resume the previous ongoing tasks manually.

This operation enables you to modify the speed and recovery policy of a HyperMetro pair.

A HyperMetro pair has been successfully configured for the storage system.

Choose Data Protection > Block Protection > HyperMetro Pair.
Click More on the right of the desired HyperMetro pair and select Modify.
The Modify HyperMetro Pair page is displayed on the right.

Modify the information about the HyperMetro pair as required. Table 1 describes related parameters.

**Table 1** HyperMetro pair parameters
Parameter	Description
Speed	Indicates the data synchronization speed of a HyperMetro pair. The value ranges from 1 MB/s to 1024 MB/s (or 1024 KB/s to 1,048,576 KB/s).
Recovery Policy	Indicates whether the system automatically synchronizes data after a HyperMetro fault is rectified. Possible options are Automatic and Manual. Automatic: The previous ongoing tasks automatically resume immediately after the remote replication fault is rectified. Manual: The value of Running Status changes to To be recovered after the remote replication fault is rectified. In this case, you can check the system and then determine whether to resume the previous ongoing tasks manually.