Configuring a Route for a Physical Port

Procedure

1. Choose Cluster > Network > Route > Physical Port.
2. Select the port for which you want to configure a route and click Configure Route.

   The Configure Route dialog box is displayed.

   

   You can also click More on the right of the desired port and select Manage Route. On the Manage Route page that is displayed, click Add to configure a route.

3. Configure the route information for the physical port.
   • Selecting New
     1. Set the parameters listed in Table 1.

        Table 1 Route parameters

        Parameter	Description
        Destination IP Address	Indicates the IP address or network segment of the service network port on the application server or the physical port on the storage device that is connected to the physical port.
        Mask/Prefix	Indicates the subnet mask of the IPv4 address or prefix of the IPv6 address for the destination service network port on the application server or destination physical port on another storage system.
        Gateway	Gateway where the physical logical port's IP address resides.

     2. (Optional) Click Add to add route configurations.
   • Select Copy from.
     1. In the Node area, click Choose to select a node.
     2. In the Port area, click Choose to select a port.
     3. In the Available Routes list, select the required route.
     4. (Optional) Click More on the right of the desired route and select Modify to modify the route information.
        

        This operation does not change the route information of the source node.

4. Click OK.