Reconnect the SMP processor cable to a system unit

Learn how to reconnect an SMP processor cable.

DANGER
When working on or around the system, observe the following precautions:
Electrical voltage and current from power, telephone, and communication cables are hazardous. To avoid a shock hazard:
  • Connect power to this unit only with the IBM provided power cord. Do not use the IBM provided power cord for any other product.
  • Do not open or service any power supply assembly.
  • Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm.
  • The product might be equipped with multiple power cords. To remove all hazardous voltages, disconnect all power cords.
  • Connect all power cords to a properly wired and grounded electrical outlet. Ensure that the outlet supplies proper voltage and phase rotation according to the system rating plate.
  • Connect any equipment that will be attached to this product to properly wired outlets.
  • When possible, use one hand only to connect or disconnect signal cables.
  • Never turn on any equipment when there is evidence of fire, water, or structural damage.
  • Disconnect the attached power cords, telecommunications systems, networks, and modems before you open the device covers, unless instructed otherwise in the installation and configuration procedures.
  • Connect and disconnect cables as described in the following procedures when installing, moving, or opening covers on this product or attached devices.
    To Disconnect:
    1. Turn off everything (unless instructed otherwise).
    2. Remove the power cords from the outlets.
    3. Remove the signal cables from the connectors.
    4. Remove all cables from the devices
    To Connect:
    1. Turn off everything (unless instructed otherwise).
    2. Attach all cables to the devices.
    3. Attach the signal cables to the connectors.
    4. Attach the power cords to the outlets.
    5. Turn on the devices.

    (D005)

To connect an SMP processor cable to a single system unit, complete the following steps:

  1. Perform prerequisite tasks as described in Before you begin.
  2. Stop all system units. Refer to Stop the system or logical partition.
  3. If necessary, open the front rack door.
  4. Disconnect the power source from the system by unplugging the system.
    Note: This system can be equipped with a second power supply. Before continuing with this procedure, ensure that the power source to the system has been completely disconnected.

    (L003)

    or

  5. If necessary, remove the left edge of the trim kit on the system rack.
    Attention:
    • Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic discharge from damaging your hardware.
    • When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It does not increase or decrease your risk of receiving electric shock when using or working on electrical equipment.
    • If you do not have a wrist strap, just prior to removing the product from ESD packaging and installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of 5 seconds.
  6. Lift the latch handle B to the open position, as shown in the following figure.
    Reconnect the SMP processor cable
  7. Align the guide pins with the connector on the system unit.
  8. Carefully push the connector A into the system unit connection.
  9. Push the latch handle down to seat the pins.
  10. Secure the plastic fastener C.
  11. Replace the left edge of the trim kit.
  12. Install the model 570 front cover.
  13. Close the front rack door.
Parent topic: SMP processor cable connections
Send feedback | Rate this page