Place the rack-mounted model 7047-185 or 7037-A50 in the operating position

By placing the rack-mounted system unit in the operating position, you make the unit available for use.

Note: Some of the figures in these procedures might not look exactly like the system unit that you have. However, the steps to perform the task are the same.

To place the rack-mounted system unit into the operating position, follow these steps:

  1. Simultaneously release the blue rail safety latches F located near the front of each rail, and push the system or expansion unit into the rack as shown in the following figure.
    Note: Ensure that the cables at the rear of the unit do not catch or bind as you push the unit back into the rack.
    Pushing the rack release latches
    1. Both rack latches should lock into position.
  2. Replace and tighten the two thumbscrews that secure the system unit to the rack.
  3. Close the front rack door. Place the system in the operating position
Parent topic: Place the rack-mounted model 7047-185 or 7037-A50 in the service position or operating position
Send feedback | Rate this page