Install the service access cover on the stand-alone model 285, 52x, 55x, or OpenPower 720

To install the service access cover on a stand-alone model 285, 52x, 55x, or OpenPower™ 720, follow these steps:

  1. Align the service access cover pins with the slots in the system. The flanges on the top and bottom of the cover wrap around the system frame, as shown in the following figure.
  2. Hold the service access cover against the system unit A and slide it toward the front of the system.
  3. Tighten the two thumbscrews B located at the back of the cover.
    Install the stand-alone model 520, 550, or OpenPower 720 service access cover
Parent topic: Install the service access cover on the model 285, 51x, 52x, 55x, 710, or OpenPower 720
Send feedback | Rate this page