By placing the rack-mounted system or expansion unit in the operating position, you make the unit available for use.
Tip: Some of the figures in these procedures might not
look exactly like the system or expansion unit that you have. However, the
steps to perform the task are the same.
To place the rack-mounted system or expansion unit into the operating position, follow these steps:
- Simultaneously release the blue rail safety latches A,
located near the front of each rail, and push the system or expansion unit
into the rack as shown in the following figure. Note: Ensure that the cables at the rear of the system or expansion unit do not catch or bind as you push the unit back into the rack.
- Both rack latches B should lock into
position as shown in the following figure.
- Both rack latches B should lock into
position as shown in the following figure.
- Replace and tighten the two thumbscrews B that
secure the system or expansion unit A to the rack as
shown in the following figure.
